The artificial grass price per sq ft in Malaysia is about RM 4 to RM 15 for the turf alone and RM 13 to RM 47 once a crew installs it. Where you land depends on grade, pile height and how much groundwork your site needs. The figure is simply the total cost divided by the area covered. That makes it the one unit you can use to compare any product, roll size or quote.
Konzept Garden sells NobleGrass rolls and drain cell sets online and installs turf for homes and commercial sites. The NobleGrass numbers below come from our own online price list.
This guide explains why the per-square-foot figure matters, how to work out your own, and what Malaysian prices look like per sq ft and per square meter. It also covers how pile height, including 40 mm turf, changes the rate, and which costs sit outside the figure.
Why price per sq ft matters when you budget a lawn
The per-square-foot price matters because it stays comparable when products, roll sizes and quotes all arrive in different formats. Without it, you compare totals that mean nothing until you know the area behind them.
One unit for every quote
Sellers price turf by the roll, by the piece, by the set or as a lump sum. A full roll covering 538.2 sq ft at RM 5,382 and a half roll covering 269.1 sq ft at RM 2,691 look far apart. Both work out to RM 10 per sq ft. Installers do the same with lump sums, so a RM 6,000 quote and a RM 9,000 quote can be identical in rate and differ only in area.
Divide every price by the area it covers before you judge it. Do that first, and the cheap-looking and expensive-looking offers often turn out to be the same deal.
Divide every quote by the area it covers before you compare anything else.
Square feet or square meters
Malaysian sellers use both units. Our NobleGrass listings use square meters, while many installers quote in square feet. One square meter equals 10.764 square feet, so you multiply a per-sq-ft price by 10.764 to get the per-square-meter price. The table converts the rates you will meet most often.
| Per sq ft | Per square meter |
|---|---|
| RM 5 | RM 54 |
| RM 8 | RM 86 |
| RM 10 | RM 108 |
| RM 13 | RM 140 |
| RM 20 | RM 215 |
| RM 47 | RM 506 |
So when someone asks about the artificial grass price per square meter, the same turf is simply RM 108 per m² where it costs RM 10 per sq ft.
What the number hides
A single rate can blur two things. The first is the split between material and labor. Turf is only part of an installed price, and installation typically adds RM 5 to RM 12 per sq ft depending on the site. A flat, empty lawn sits at the low end. Rooftops, odd shapes and areas needing leveling or drainage work push toward the high end.
The second is project size. Fixed costs such as transport, base materials and crew setup spread across fewer square feet on a small area. A 100 sq ft balcony will usually cost more per sq ft than a 600 sq ft garden using the same turf. Keep that in mind when a friend quotes you their rate from a different-sized project.
How to work out your own price per sq ft
You get your own figure in three steps: measure the area, apply a material rate, and add installation and a buffer. The result is a budget window you can check against any quote.
Steps to a working estimate
- Measure length and width of each area in meters or feet. Split irregular shapes into rectangles and add them up.
- Convert to one unit. Multiply square meters by 10.764 to get square feet.
- Choose a material rate from the grade you want (see the Malaysian ranges in the next section).
- Add installation at RM 5 to RM 12 per sq ft, depending on site difficulty.
- Add a 10% to 15% buffer for leveling, drainage, edging or removal of an existing lawn.
A budget is a window, so calculate it with both the low and the high rate.
Worked example: a 400 sq ft lawn
Take a flat garden of 400 sq ft, which is about 37.2 m². Assume a Cruz-class grade at roughly RM 10 per sq ft for the turf.

| Item | Low | High |
|---|---|---|
| Turf, 400 sq ft at RM 10 | RM 4,000 | RM 4,000 |
| Installation, RM 5 to RM 12 per sq ft | RM 2,000 | RM 4,800 |
| Subtotal | RM 6,000 | RM 8,800 |
| Buffer, 10% on low and 15% on high | RM 600 | RM 1,320 |
| Total | RM 6,600 | RM 10,120 |
That is RM 16.50 to RM 25.30 per sq ft, or about RM 178 to RM 272 per m². Use this window to test a quote. A figure far below it deserves questions about base depth and drainage, and one far above it deserves a request for a line-by-line breakdown.
What to send for an accurate quote
An estimate gets you to a range, but only the site settles the final figure. To prepare a quotation, we ask for photos and measurements of the area. If you want a visit, we charge a RM200 site visit fee, which is deducted from the final quotation if the project goes ahead. After a site visit we typically prepare a proposal within 4 to 5 days. Having your measured square footage ready means the conversation starts at your real rate rather than a generic one.
Artificial grass price by grade in Malaysia
For turf alone, Malaysian prices run from about RM 4 per sq ft for entry grades to roughly RM 15 per sq ft for premium residential grades. Installed projects commonly land between RM 13 and RM 47 per sq ft, with the top end reserved for specialist surfaces and difficult sites.
NobleGrass prices per sq ft
Our NobleGrass range has three grades: Valu 30, Cruz 30 and Premium 35. Prices below come from our online listings. Rolls start at a 1 m x 1 m cut, while the drain cell sets are 50 cm x 50 cm tiles sold four to a square meter, built for balconies, rooftops and other hard bases.
| Grade | Roll, 1 m x 1 m from | Roll per sq ft | Drain cell set (1 m²) up to | Set per sq ft |
|---|---|---|---|---|
| Valu 30 | RM 69.90 | RM 6.49 | RM 99.00 | RM 9.20 |
| Cruz 30 | RM 105.00 | RM 9.76 | RM 139.00 | RM 12.91 |
| Premium 35 | RM 145.00 | RM 13.47 | RM 165.00 | RM 15.33 |
Wholesale rolls bring the rate down further. The Valu 30 roll of 2 m x 25 m (50 m²) is listed at up to RM 2,588, or RM 4.81 per sq ft. The Cruz 30 roll of 4 m x 15 m (60 m²) is listed at up to RM 4,135, or RM 6.40 per sq ft. These suit developers and large lawns, since you buy the whole roll. You can browse every size on the NobleGrass artificial grass collection.
Roll turf is the cheapest route per sq ft, and the drain cell set is the right one for hard surfaces.
How the wider market compares
Published retail listings from Malaysian suppliers show the same spread. Entry-grade turf starts near RM 4 per sq ft, mid-range 25 mm rolls sit around RM 10 per sq ft, and premium grades go higher. Putting-green and sports turf cost more again because of tighter yarn and infill requirements.
Treat any list price as a material-only starting point. Delivery, base preparation and labor all come on top. Use these figures to sanity-check a quote, not to replace one.
What moves the price: pile height, density and backing
Pile height, yarn density and backing are the three product specifications that move the price most, and your site and project size decide the rest. Knowing them lets you pay for what you need and skip what you do not.
Pile height and 40 mm turf
A taller pile uses more yarn, so price rises with pile height. Our own range shows the pattern. Moving from Cruz 30 to Premium 35 lifts the starting roll price from RM 9.76 to RM 13.47 per sq ft. Part of that jump comes from grade, since yarn and density change as well, so height is not the only factor.

If you are pricing 40 mm turf, expect it to sit at or above the Premium 35 level. NobleGrass does not currently list a 40 mm grade, so ask for a quote against a specific product rather than relying on a generic rate. As a rule, 40 mm to 50 mm suits residential lawns where realism matters, while 20 mm to 30 mm suits balconies, decorative strips and light-traffic areas. Choosing the height your use actually needs is the quickest way to cut cost without hurting performance.
Density, yarn and backing
Two grasses with the same pile height can differ sharply in price. Denser stitching and thicker yarn last longer under foot traffic and pets, but they cost more to make. Backing quality matters for drainage and for how well the turf holds its shape in Malaysian rain, so it is worth asking what the backing is made of before you accept a low rate.
Look at the weight too. In our roll listings, a 1 m x 3 m piece weighs 6.0 kg in Valu 30, 7.3 kg in Cruz 30 and 8.4 kg in Premium 35. Heavier rolls hold more material, which explains much of the price difference. Comparing weight per square meter is a fast way to tell whether a cheap roll is really a thinner product.
Project size, shape and slope
Site conditions change the installed rate more than most people expect. Small areas cost more per sq ft, as covered earlier. Curved edges and slopes take extra cutting and fixing time, and rooftop work adds weight limits, waterproofing and restricted access. When you compare two installed quotes, check whether they assume the same kind of site. A flat rectangle and a sloped, irregular garden should never carry the same rate.
Pay for the pile height and density your use demands, and nothing above it.
Costs outside the per-square-foot figure
Several costs sit next to the turf and labor rate, and leaving them out is how a good-looking quote becomes an expensive project. Ask each installer to list them as separate lines.
Groundwork, edging and removal
Preparation decides how long your lawn lasts. A proper compacted base and drainage layer cost money, and a cheap quote often saves on exactly this. Removing an existing lawn, leveling uneven ground and fixing drainage add labor hours. Edging is needed if no wall or pavement contains the turf. Infill such as silica sand is also required for most mid-to-high grades to keep blades upright and drainage working.
If you deliver and fit the turf yourself, our rolls ship to anywhere in Peninsular Malaysia. A DIY job removes the labor line, but not the base work, so budget for it either way.
Why the cheapest quote can cost more
A quote 30% below the others is rarely a bargain. It usually has a thinner base, a lighter grade or fewer seams done properly. Watch the signs: no mention of base depth, no named turf grade, and no breakdown between material and labor. A fair quote names the product, states the area in square feet or meters, and shows the rate.
Over the years, replacing failed turf costs far more than getting the first install right. A good lawn also lasts, and a quality artificial lawn typically runs 10 to 15 years, so a slightly higher rate on day one spreads thinly across a long life.
The lowest rate usually trades away the base, and the base is what you cannot see.

Plan your turf budget with real numbers
The artificial grass price per sq ft is the figure that makes every quote comparable. In Malaysia it runs from about RM 4 to RM 15 for the turf and RM 13 to RM 47 installed. Pile height, density, backing, project size and groundwork explain almost every gap between two offers. Convert each quote to one unit, run your own low and high estimate, and check what the installer includes.
If you want a figure for your own space, send us photos and measurements and we will quote against a specific NobleGrass grade. You can talk to our team and request a free quote and get a number built around your site instead of a generic average.




